Outer Limits 4x4 Board

hi ive recentally put a 5-6 inch lift on my patrol and the front drivshaft is rubbing on the gearbox crossmember whilst sitting on level ground how do i fix that? ive been told just to smash it with a hammer. any help is appreciated i wana get out there and test it out
cheers aydan

smashing it sounds a bit ruff lol. with 6 inch im gessing its a bit of a wepon so id consider finding yourself a local fab shop and getting a custom one made up or im gessing sum1 probaly sells one. id steer clear of smashing or chopping the factory 1 could brake it.

Put a notch in it:

if your handy with a grinder and welder you could notch a section out and put a piece of pipe cut in half back into it. but if its rubbing at ride height might not give you enough. i need to take a skim off mine in a shorty with a 4 inch as it rubs at full droop just a tad

yea that sounds like the go smashing it sounds a bit ruff to me as well hahah cheers fella's

don't bother with the pipe, just plate it. The outside section left from the pipe does nothing, so why not cut it right off.

what do you mean buy that? got any pics?

CAn you turn the shaft around like people do with the rear tail shafts when lifting the patrols so the skinny/slide bit is over the cross member

Doesnt get much simpler than this

If You Go Into The Members Forum And Check Out My Thread Theres More Photos

cheers mate.