Outer Limits 4x4 Board

ok first off i noticed me spotties would blink off then come back on, then they wouldnt work, flick the spotties switch a few times and they come on again. mate reackons its a relay. anyone else had this?

also my indicator would jus stay on with out blinkin a few times, only way to get it to turn off was to flick the indicator till it went out. anyone know wat i should be looking at?

sounds like your ind. stalk is giving up cos both your problems are linked back to the stalk. plug in a diffrent one to see if it is the problem. just an idea.

sorry but whats an stalk?

Kingston_99 wrote:sorry but whats an stalk?

"Stalk" is the lever thing on the steering column that you use to turn the blinkers on.

Try and pull the column apart and spray some contact cleaner on the connecting plates for the stalk. A lot of dust and grime gets in there.
Also I don't know what type of arrangement you have for your spot lights but you should check the signal wire connection for the spotlights. That’s going to be the one that should be connected to the high beam, working like an actuator.
However people connect them to parkers and low beam lights so that they can flash their spoties at any time. This is not legal. Not that anyone cares.
If all the connections are good, earth etc... Check the relay. Make sure that the in-line fuse ect... is secure.

i fixed the inacators.

the problem was when i hard wire my bull bar indacator two of the wires were touching each other, must of been the park ligths and indacotor. but i wrapped them in tape and now fixed that.

still havnt fixed me spotties. mite try and put a new relay in.

i took the stearing coloum out and had a look and sprayed with contact cleaner and hasnt done anything. so i reackon a new relay.

thanks for the help guys

chimpboy wrote: "Stalk" is the lever thing on the steering column that you use to turn the blinkers on.

I thought they delivered babies.