Outer Limits 4x4 Board

Hey,
I have not long bought my self a swb ng paj with the 2.6l 4g54 carbied motor.
I have taken it out twice and both times i have been through tiny mud holes (less then a foot deep).
The paj is fine after goin through them, it isnt untill further on it the day (last time whilst goin up a steep rocky climb) it lost power.
when i say lost power, the paj pretty much just dies but wont stop completely (it will idle fine) it is just the higher revs it doesnt like for a minute or 2 then it will go back to being fine again.
Any help would be great.

Also can any one shead some light on how to water proof these engines to a certain degree? tips/tricks?

Thanks in advance

it could be float level? if its on hills

is trere any way of stopping that. this is my first carbied car, if it was injected it wouldnt be near as hard for me to figure out

check this thread out on carbies mate http://www.outerlimits4x4.com/ftopic186736.php