Outer Limits 4x4 Board

I have just replaced the lower rear trailing arms (control arms) on my 2003 GU Petrol. The handbrake cable was attached to the original trailing arms by a bracket that was welded on, i think it was to secure the cable and also prevent it frm getting nipped against the chassis when the wheels are articulating. What has anone else done to secure the handbrake cable when replacing the factory arms? Photos would be really appreciated.

Cheers

Steve

<Cross posted to Patrol4x4>

Worm Drive Hose clamps, the cheapy ones.
Don't over tighten

I usually weld a nut onto the arm then bolt a clamp onto that.. i will have pics somewhere if you want..

cheers mark.