Outer Limits 4x4 Board

Hi Guys,

For a Vitara G16b...did you put a heat shield on?

The heat shield doesn't fit on anymore, and even if it did there are no mounts. I am wondering if I should make one up?

-------------------------------------
Other notes about the Headers
-------------------------------------

Fitted up mostly ok, they don't thread the mounts for intake pipes, which meant I had to get some bolts (M8.20 I think I used for those wondering) Would have been nice if they told me that so I had them ready to go.

It doesn't have the mount that goes half way down the dump pipe. Only about 2mm clearance to the engine, but Liverpool Exhausts (the supplier) says it wil be fine.

I didn't do the cat/exhuast yet, but there is a noticible difference under load. It can go a little harder up a hill. The main place I noticed is out of my driveway it usually coughs a bit getting out, but goes out fine now. Hill leaving my place I usualyl have to go back to first, holds in 2nd now.

Cheers
Chris

[rant on]

Very OT but what's the deal with mismatching/ ill-fitting headers ???

This is nothing against eXc but from the other case of headers not lining up etc in a GV does the aftermarket manufacturers of these brands of headers actually do any proper measurements?

I realise not all vehicles line up perfectly but some of the stuff you see on Outers regarding ill fitting equipment which is meant to be designed for the vehicle is shocking.

[rant off]

I have them on a G16B in my sierra and they are perfect No heat shield.

I put a set on my Vit when I had it 5 years ago. Had to do a bit of filing to get the holes the right size/aligned at the exhaust end.

I wouldn't worry too much about the heat shield. If you are concerned though, there is special tape you can wrap around your headers. PITA though.

Thanks for the replies.

Yeah I have used the tape before.

Good to know others haven't had a problem, but I decided last night it shouldn't be hard to make some brackets up, so I made up some brackets last night, only took an hour and I should be able to get the heat shield back on, just won't be a perfect fit. Just gotta weld a nut or bolt on and paint the brackets now

My concern is the air con line and the rubber air intake near the exhaust and this dodgy up will protect them.

i just bought some hurricane headers and there not fitting did you guys have to heat them up, because mine are hitting the gearbox

They the G16B ones?

if so they list two different extractors from memory with one coming in sharper than the other.

damn so back to the shop

mine have about 2mm clearance