Page 1 of 1
bellhousing seal up
Posted: Thu Oct 15, 2009 6:48 pm
by waandy
done another thrust bearing not long after i replaced the clutch and im just wondering if many people seal them up? and if so how? im sure it would have been the muddy water i play in thats stuffed it
Posted: Fri Oct 16, 2009 6:30 am
by macneil
i used gasket goop allround mine hopefully that holds it other wise any sealen that can take a bit of heat..
Posted: Fri Oct 16, 2009 6:46 am
by garth
Gudday
get in there with the Sika before 'button up' and run a generous bead right around the housing.
make sure the bung and the clutch boot are in good nick and secure.
good luck
Posted: Sun Oct 18, 2009 8:09 pm
by gu town
gasket goo all around, new clutch fork boot + more goo. i also drilled and tapped a breather up on top of bell housing. just for heat from clutch (pressure differences) in my old GQ anyways.