Outer Limits 4x4 Board

im 99% sure they are metric (as they are jap made) but want to double check.

I'm trying to work out what size the nut on the front output shaft is from the transfer.

not the 4 which undo the the actual drive shaft, but the staked nut which holds the flange on.

my verniers are reading 27.3mm, so at a guess 28mm but i dont find this a very good way of working it out as ive bought the wrong socket before.

any help would be great.

all metric unless someones replaced them at some point (possible on older sierras etc).

27mm socket will fit. They should be 27mm flanged nuts unless someone has previously molested them.

Dan

JrZook wrote:27mm socket will fit. They should be 27mm flanged nuts unless someone has previously molested them.

Dan

yep 27mm on my wt transfer

27 for sure.

PS there are imperial fastener on a sierra - Seatbelt bolts are imperial (actually an SAE spec), as they are in every car.

Steve.

sweet new seal fitted. thanks. now for that damned bush

Metric unless you have calmini bits

i swear that the four bolts behind the disk bake that hold the wheel bearings on are imperial on my lwb and metric on my shorty...

Everyone knows the nuts on sierra's are f'n huge, or maybe it's just the drivers.