Page 1 of 1

Bundera. Spring lift Question!

Posted: Fri Oct 30, 2009 11:52 am
by HemRz
Hello all i have a Toyota Bundera.

i have been looking at putting a 2 inch body lift on it as i already have a 2 inch spring on.

i have recently been told that a 80 series Spring kit will fit under my bundera and the 2 inch 80 series gives the bundera a 4 inch lift.

i was just wondering has anyone done this before? and is there much work involved in putting the 80 series 2 inch on a bundera? and what else will i have to do etc to the car to get it all working good?

Regards HemRz!

Posted: Sun Nov 01, 2009 8:33 am
by Sentinel
Hey mate, here is another thread from a little while back about putting springs in a bundera.
I think from memory you use 80 series front springs, rear are too big. Standard 80 springs will give you about 3" of lift.

Have a read mate...
http://www.outerlimits4x4.com/ftopic176 ... highlight=

Posted: Mon Nov 02, 2009 2:43 pm
by HemRz
Sentinel wrote:Hey mate, here is another thread from a little while back about putting springs in a bundera.
I think from memory you use 80 series front springs, rear are too big. Standard 80 springs will give you about 3" of lift.

Have a read mate...
http://www.outerlimits4x4.com/ftopic176 ... highlight=
Awesome stuff Normal 80 Fronts for the front and heavy duty 80's fronts for the Rear.

it dosnt mention anything about the shocks does anyone have the answer for this?

would be much appreciated and ty! again Sentinel

Posted: Wed Nov 04, 2009 5:26 pm
by HemRz
Bump.

Would i use the Shocks from the 80 series or os there a diffrence aswell?

Posted: Wed Nov 04, 2009 11:28 pm
by pozman
im running ome 80 shocks with mine, seams to go alright, pretty cheep lift, and the flex aint to bad, for a bundy

i think one of the rear ones is either too long or too short as the rear set up is a bit weird

one of the rears will need the eye from the old shock welded on instead of the pin the 80 has, i welded mine on myself and haven't had an issue yet after quiet a few kays

with that much lift it tends to steer a bit shit cos of the caster issues, but you can run 80 correction bushes, they will need to be pushed into the bundys outer ring of the bush as the 80 ones are smaller, seems a bit booty fab but pedders did it for me and they were happy with it