Page 1 of 1

85 hilux dash

Posted: Mon Nov 02, 2009 7:36 pm
by 19richo90
hi all,

got my dash all plugged in and screwed in and the whole right side of it doesnt work, speedo, fuel gage and it doesnt illuminate, just wondering if anyone has any ideas why?

thanks

Posted: Mon Nov 02, 2009 10:00 pm
by Canyonero 4x4
19richo90 wrote:hi all,

got my dash all plugged in
No you haven't.
There's a few plugs to connect into the back of the instrument cluster. Pull it out and check that they're in PROPERLY
Same deal with the speedo. It's a c*nt to connect, just have to sit there wiggling it and twisting it until it the little spline lines up properly. You'll know when it's on.

Posted: Mon Nov 02, 2009 10:22 pm
by TUF-35T
i have the sme problem but its intermittent so its just a bad connection somewhere

shane

Posted: Wed Nov 04, 2009 12:26 pm
by 19richo90
Same deal with the speedo. It's a c*nt to connect, just have to sit there wiggling it and twisting it until it the little spline lines up properly. You'll know when it's on.
do you have to tweist it much, cause mine doesnt seem to twist that much, how do you know its in properly like will it cick in or anything?

cheers

Posted: Wed Nov 04, 2009 1:39 pm
by thrashlux
please clarify on that side
is the dash not working ie the guages not moving + no back light
or is it just no back light

if the former it could be a bad earth u could try a temporary earth and see if it starts working

Posted: Wed Nov 04, 2009 9:36 pm
by Canyonero 4x4
19richo90 wrote:
Same deal with the speedo. It's a c*nt to connect, just have to sit there wiggling it and twisting it until it the little spline lines up properly. You'll know when it's on.
do you have to tweist it much, cause mine doesnt seem to twist that much, how do you know its in properly like will it cick in or anything?

cheers
There's a little pin inside the plastic shroud. Depending on how much you've moved it already or how much it was knocked about whilst the dash was out you may have to twist the actual pin. It is round with a flat surface. This flat surface must line up with the flat surface in the back of the instrument cluster.
When it's in it should slide all the way on and click. If it's on and clicked it shouldn't slide back off without pushing the clip in.
If you think you've got it, give it a light tug.
I hope this make's sense.

Posted: Fri Nov 06, 2009 7:34 pm
by macktuff
l agree with canyonera 4x4 l had my dash apart put it back together everything worked but illumination if you've followed all the advice so far and no avial trace all your connectors using hilux repair manual

with my illumination not working the cause was the dimmer switch for lights which is just below the handbrake on the left side of steering wheel it was rusted and corroded pluggin it in blew fuses it was faulty trip to wreckers fixed it