Outer Limits 4x4 Board

I need a picture of the No.3 water bypass pipe and the other pipe that's attached to it (a vacuum line i think). It's the pipe that comes off the turbo cooling water.

I also need to know what diameter the pipes are. I did have one, but during my rebuild, it's gone MIA and they can no longer be purchased. Not even through Toyota Japan. I have to make one I guess. Unless someone knows where to get one.

Here is a link to toyodiy. If you look at the Bottom right corner its there.

http://www.toyodiy.com/parts/p_G_1986_T ... _1603.html

16279 PIPE, WATER BY-PASS, NO.3
16279-68020 12HT..HJ61

Any info is much appreciated.

I have a 12HT sitting on the floor in the shed.
Not sure of ID but OD of small pipe is 4mm and runs from vacuum on alternator.
Again not sure of ID but OD of bigger tube(water) is 8mm.
I can send you some pics if you give me an email address,not a big enough computer nerd to figure out how to upload on to this site,although its probably easy.
cheers
Richard

I cant give you these ones but i could take them off and make up templates out of coat hanger wire and post them to you.
might cost you a slab though.