Outer Limits 4x4 Board

Just put a new clutch slave cylinder in but i cant get enough travel out of it to allow me to change gears. I thought of making a longer pin but then on the same token dont want the bearing rubbing , on the clutch fingers anyone got any ideas.83lux with 308 convers.

Hi Webby
Marks adp make a sleeve to reduce the size of the gq slave in the chev conv.This gives the slave more travel.
Can you fit a smaller bore slave or a larger bore M/C.
Normally a longer push rod wont fix it ,unless the slave is coming to the end of it's travel,ie mounted too far away.
J Top

try dellows automotive in sydney they had everytheing i needed