Outer Limits 4x4 Board

Gota GU wagon with 35" creepy crawlers(2 Small)i would luv ta run
37 xterrians or MTRs in a pinch, anyone runing them? how much lift do i need? got rock hoppers so turning them in the bush is no problem.

Thanks for any input Grant.

i run 38s on 10"rims with a small amount of guard cut inside wheel well.
7"lift on a ute.

I have a pic i cansend ya of a white gu wearin 37"s that i think sandy bowman done the work to im sure they fitted with just a 4" lift looks fugin sweet as

A1MAV wrote:I have a pic i cansend ya of a white gu wearin 37"s that i think sandy bowman done the work to im sure they fitted with just a 4" lift looks fugin sweet as

Thank for your reply, i would luv ta see a pic of this GU wearind big boots

what about mannell motors, GU on 38.5 swampers i think. the one that was in tuff truck.

i know that a GU with 4" srping looks big with 35s and 37s might fit with a little trimming if needed, though i am not entirely sure.

a member of our club has 37 claws on his GU. 5-6" spring lift, 5 link front end. I believe a little choppy on the rear of the guards

i have gu coil ute with 37's 5 inch no scrubbin at all

Thats not a bad grave dig for a first post.

5inch flexy superior eng kit but going back to 3 inch coil with 37s and long shocks
trim the front plastic flar and rear quarter chop
38s


rear chop
37s

when i had the 38x13.5 they were on 15x10-44
37x12.5 are on 15x8-25
hope that helps any

38s

mate have you done the 3" convertion yet and how did it go i have a 3
' lift in mine and have been wondering what it would take to get some 36 or 37's under there successfuly. i will be back on the coast soon so ill get back to ya about that rear bar