Outer Limits 4x4 Board

gday

i have looked in the stickys and searched but havent found found much of what im after.

I am gettin a panel beater to cut my quarters and weld plates in there on wed. I know what i want it too look like but it is hard to describe it.

If anyone has some pics of there quarter chops that they want to show i would appreciate it. cheers. Especially anything that shows the cut line and plate welded in.

thanks

seach is your friend

this thread found using search reveals the answers to your question

http://www.outerlimits4x4.com/viewtopic.php?t=70903

yeh thought that was aimed moreso at bar design... already read it through.

rumpig89 wrote:yeh thought that was aimed moreso at bar design... already read it through.

it shows where to cut and where the plate goes, not sure what you are after beyond that as this is all you asked for

Have some progressive photos of the quarter chop done on my GQ, not sure about the photo posting just doesnt seem to work for me but can PM me email if that helps.

heres a diy thread

http://www.mudrhino.com.au/Docs/DIY2.pdf