Page 1 of 1
nother anti rap design
Posted: Tue May 25, 2004 6:45 pm
by redzook
http://www.pirate4x4.com/forum/showthread.php?t=253491
i gotta get another rap bar on the rear of my zuk
now some i know said this wouldnt work (names dont matter
)
so can some 1 set me straight will it stop rap
tim
Posted: Tue May 25, 2004 6:57 pm
by N*A*M
it may stop axle wrap, but i doubt it would stop eninem or wu-tang.
Posted: Tue May 25, 2004 6:58 pm
by spazbot
i recon it would work, but it looks like alot of effort to make , there are prolly alot easier options you could use
Posted: Tue May 25, 2004 7:14 pm
by chimpboy
Yeah, if you like the concept I think it would be improved by replacing the slotted component with a shaft, and having the shaft pass through a sleeve/eye. Much less difficult to fabricate and less likely to bind anyway.
The idea would be that an upright shaft attached to the axle (in the same way as the slotted component in your pic) can slide freely up and down in an "eye" attached to the chassis.
The eye would be able to swivel to allow for the upright shaft's changing angle, but wouldn't allow the upright shaft to move forward or backward.
Same basic mechanical principles as what you've posted but I think stronger and definitely easier to fabricate.
Jason
Posted: Tue May 25, 2004 8:47 pm
by ToNkA
N*A*M wrote:it may stop axle wrap, but i doubt it would stop eninem or wu-tang.
LOL.
Posted: Tue May 25, 2004 9:53 pm
by N*A*M
got bored so decided to try visualise jason's concept. is this what you mean, sort of?
Posted: Tue May 25, 2004 9:56 pm
by chimpboy
N*A*M wrote:got bored so decided to try visualise jason's concept. is this what you mean, sort of?
Heh, yeah, that's getting there you know...
I think the eye needs to be gimballed so it can allow angle changes in more than one plane... but yeah, nice.
When I get bored, I try to visualise my concepts too
Sketch:
The vertical bar (I drew it square, it would probably be round tube I guess) can slide up and down in the eye.
Make sense?
Jason