Outer Limits 4x4 Board

can any one tell me what disc rotors are run when useing ifs front hubs on a landcruiser. also is there a off the shelf rotor that will fit with out useing a spacer

Here is a catalogue that should help you find what is available ...
http://www.dba.com.au/2006/catalogue_aust.asp

i don't know of an off the shelf option...

http://www.sky-manufacturing.com/new/

http://www.sky-manufacturing.com/new/de ... php?id=127

and just use cruiser rotors.

hth's
crusty

Try this one cheaper and better


http://www.ebcbrakes.com.au

thanks guys good info there. they were saying on sky manufacturing site that the v6 ifs calipers were the largest caliper. can anyone confirm this for me bit unsure as the later cruisers have bigger calipers than early models

Been told the same thing doe.
I do know that the cruiser brake pads fit V6 calipers, but that does not mean they are exactly the same.

Pics of my V6 calipers if it helps you ...

45mm V6 caliper vs early Surf 42mm caliper (later Surfs had 45mm V6 caliper)

hey dougster thanks for your help. looking at your pix it looks like the early 42mm surf has a smaller brake pad than the 45 mm caliper. that is the same i found with the early to late model cruiser. im not in shed at moment but will have a look at part numbers on my calipers maybe they are same. cheers scott

hey dougster thanks for your help. looking at your pix it looks like the early 42mm surf has a smaller brake pad than the 45 mm caliper. that is the same i found with the early to late model cruiser. im not in shed at moment but will have a look at part numbers on my calipers maybe they are same. cheers scott

had a look at my calipers differant numbers but close to the 42mm ifs one. my calipers are also 42mm. will have to go to wreakers an have a good look at a set of 45mm. dougster do you no what diameter your rotors are? is that rotor one solid piece or is there a spacer on them also cheers scott

When fitting IFS hubs to a landcruiser with a hub widening kit (ie a spacer) you use the standard rotors.

Yes, on mine I used a "wide track kit" from Marks on an IFS front hub to match the IFS rear width.
It's a 30mm spacer I think from memory and the 60 series rotor bolts to the spacer.

Not all Hilux rotors are the same, so check the link below to see if your std ones will work with the Marks kit. 60 series are 49mm in height when laid flat on a bench.
Most will work, just the rotor spacer will need to be a different thickness.
http://www.dba.com.au/2006/catalogue_aust.asp

HTH.