Page 1 of 1

hd-ft max fuel adj

Posted: Tue Jan 12, 2010 12:56 pm
by mozza
Gday all, have fitted saf i/c kit .spaced the wategate and now looking at adj max fuel ,I am assuming it is the spoke socket long adj screw straight out the back but cant confirm in any manual, so im calling on the vast knowledge of the outerlimits toyota crew to guide my hand ....any help much appreciated ...

Cheers all Mozza

Posted: Tue Jan 12, 2010 1:07 pm
by Auto-Craft
Thats normally the last adjustment, after doing timing, plunger, and off boost fuelling, then adjust the fuel, which also adds to the others.

lcool.org there is a good tech document on how to do your pump adjustemnts, and how to set them.

HAve you chnaged exhaust ?

Have a pyro fitted to adjust/tune it ?

Posted: Tue Jan 12, 2010 1:11 pm
by mozza
GDay Mate , yes has 3" system and pyro pre turbo and all LCOOL adj c/out , running heaps cooler than previously and final adj ready to c/out , i believe 1/16 increments are the go and am assuming that the screw i mentioned is the correct one?
Cheers for the reply mate ...

Posted: Tue Jan 12, 2010 5:12 pm
by Auto-Craft
If you have done all the other mods and exhaust, start with 1 full turn, should be pretty close, if its not been touched before.

go in 1/2 turn increments.

Posted: Thu Jan 14, 2010 7:18 pm
by mozza
Gday again ,have cranked up to 2/3 of a turn after trying 1/2 turn , loving the change and temps are not up to pre install levels as yet and the engine dosent work any where near as hard as before ,in regards to boost pressures when c/control engagued only small increment s on long hills to maintain speed .All in all very happy with results so far , should have done it years ago!!!!

Re: hd-ft max fuel adj

Posted: Fri Jan 15, 2010 5:58 am
by Hamo
mozza wrote:Gday all, have fitted saf i/c kit .spaced the wategate and now looking at adj max fuel ,I am assuming it is the spoke socket long adj screw straight out the back but cant confirm in any manual, so im calling on the vast knowledge of the outerlimits toyota crew to guide my hand ....any help much appreciated ...

Cheers all Mozza
Where did you buy the safari kit from and if you dont mind how much $$
PM if you like I'm doing the same soon very soon

Posted: Sat Jan 16, 2010 6:08 pm
by mozza
Gday Hammo, Motsons 4x4 in brisbane will suppy kit for @ 2 g's or Armadale 4x4 in Perth for the same , most places who stock will not supply only but will fit /supply for @ 3200 ,hit up your local supplier and tell them you can get it from either them or Motsons and they might come to the party ,that is what I did with Armadale over here .


Enjoy Mozza.

Posted: Sat Jan 16, 2010 8:31 pm
by Hamo
mozza wrote:Gday Hammo, Motsons 4x4 in brisbane will suppy kit for @ 2 g's or Armadale 4x4 in Perth for the same , most places who stock will not supply only but will fit /supply for @ 3200 ,hit up your local supplier and tell them you can get it from either them or Motsons and they might come to the party ,that is what I did with Armadale over here .


Enjoy Mozza.
Thanks mozza Yep i've heard of the supply & fit bit but be damed if i'm going to pay some one to fit it when i can do it my self