Page 1 of 1
Intake temp gauges/senders
Posted: Wed Jan 20, 2010 6:29 pm
by Feenz
Has anyone tried the Nordskog air intake temp sender and gauge from Frozenboost.com?
Or is there a reliable / accurate enough gauge from the auto shops that someone's used?
Posted: Wed Jan 20, 2010 8:44 pm
by Clanky
permanent fixture or just for testing?
For testing you can get a cheapy digital thermometer from Dick Smith or Jaycar that can slip under the rubber hose
Posted: Wed Jan 20, 2010 9:13 pm
by drew4130
Yeah I fitted one and it works OK it reacts slowly and I think it get a fair bit of heat soak from intake bend before the plenum??!! going to mount it differently when the water to air is on... only reason I think it reacts slowly is im comparing it to the air temp sensor on an old car I had with a Microtech and a hand set and it was instant...
Posted: Thu Jan 21, 2010 6:48 am
by 8maddog8
I am looking for one of these also. The only thing about the Nordskog is its in deg F....
Posted: Thu Jan 21, 2010 10:22 am
by tagz281
Why not use a Auber digital gauge. I use one as my pyro and it is very responsive and also records high/low temps. It also allows you to run a alarm or a warning at a selected temp.
http://myworld.ebay.com/ebaymotors/auberinstruments