Page 1 of 1
mounting ifs box
Posted: Sun May 30, 2004 8:33 pm
by STUMPY
i'm about to do a cross over steering on the 4runner and was wondering what the best way of doing it? instead of putting tubes inside the chassis rails can i have a bit of plate on the other which would stop the rails from crushing? and who steering arm do you recommend? feedback and photo's would be great.
cheers joel
Posted: Sun May 30, 2004 9:13 pm
by Samuel
You will need crush tubes for an engineer to pass it. they arent hard to fit, if you can weld good.
Use the proper high steer arms and rod set from snake racing.
Posted: Sun May 30, 2004 9:30 pm
by STUMPY
is there any specific wall thickness and diameter of the tubes?
do you need drill a hole the same diameter as the tube then weld it in place, or drill a hole the same diameter as the bolt and let the bolt hold them in place?
Re: mounting ifs box
Posted: Mon May 31, 2004 7:31 am
by Surfin Alec
STUMPY wrote: and who steering arm do you recommend? feedback and photo's would be great.
cheers joel
Sam from Overkill made my arms, mate if you can bend those suckers you doing something wrong. The pipe has got about a 10mm wall thickness
.
Just posted pics of them on the other SAS thread.
http://www.outerlimits4x4.com/PHP_Modul ... hp?t=19480
Cheers,
Alec
Posted: Mon May 31, 2004 8:57 am
by STUMPY
i'll give sam a call
sounds good
Posted: Mon May 31, 2004 10:36 am
by dumbdunce
just get cater to weld that steering box onto the frame with his stick welding skillz, don't worry about any of that crust tube nonsenze
Posted: Mon May 31, 2004 1:03 pm
by STUMPY
Is that team bootie fab
i heard about those guys
come to think of it, aren't you te founding member
Posted: Mon May 31, 2004 3:02 pm
by dumbdunce
yers that's us! we can fixx0r it all good! have hammer and chizel!