Outer Limits 4x4 Board

Can any1 tell me if a GU rear center will fit into a GQ rear housing and axles.

Yes I put a GU 4.6 into my gq wagon, the only think i had to change was the yoke where the centre nut is as the GU's have a different holes setup and will not fit to a Gq tail shaft.

As long as its not a H260 (rear) from a GU. Some of the manuals (ZD30 and TB45) have H260's.

The most sought after (out of 2.8's) with the 4.6's are H233, so you're good!!

well bugger I missed ur post Bigbluemav. I got a gu rear center looks like Its could be a h260. The OD is heaps bigger. Is there any where on the center to tell what kind it is. The Gu center is 4:1.

NissanTuff wrote:well bugger I missed ur post Bigbluemav. I got a gu rear center looks like Its could be a h260. The OD is heaps bigger. Is there any where on the center to tell what kind it is. The Gu center is 4:1.

Bummer!! It must have come out of manual TB45 or TD42T? All I know is that they are physically HEAPS bigger.

Anyone else able to offer any assistance?

Measure the diameter of the crown wheel. H260 = 260mm. H233 = 233mm.

Tony

Yep its a H260. So any1 wanna buy a rear 4:1 H260 out of a GU. Thanks 4 ur help fellas .

Not all TD42T's have H260's

Just replaced the rear diff in a GU 2000 TD42T and it was running HG39 Diffs which are H233B 3.9:1 Ratio

MyGQ wrote:Not all TD42T's have H260's

Just replaced the rear diff in a GU 2000 TD42T and it was running HG39 Diffs which are H233B 3.9:1 Ratio

I'm not sure what the 'rule' is with diff sizes and ratios etc. BUT, I thought manual TD42T's had 4.1's and 3.9's were auto's (attached to TB45's)

Well not sure what it is now. But would like to find out so i can sell the thing. All I know its out of a GU Rear and its 4:1. And dont fit in my 96 GQ wagon td42.