Outer Limits 4x4 Board

Ok ive just finished nightshift and im tired but i can only see one circlip on the axle side, there is another one inside how do i get at it to part the axle and cv?

It would help if you told us which vehicle???

For most solid axle assemblies, holding the cv vertically and whacking the bell with a rubber/leather hammer will release the axle

Ah yes i told you i was tired

60 series cruiser

Ok i got the cv bell off the axle but bashing it off breaks the circlip on the very end of the axle (inside the bell) when i replace with a new CV how do i get the circlip back on?? There is no possible way i could get to it once the axle is in there.

The only way i can think of is compress it like rings on a piston and slide the bell over it and down the axle, is this the correct way?

Circlip goes in the groove before you refit the cv. Its a destroy to remove and fit a new one thing.

I did this, a small spot of weld on the inner wear line of the spline. Hope it helps.

http://www.outerlimits4x4.com/ftopic118 ... weld++wear