Outer Limits 4x4 Board

Ok So i pluged the ECUtalk cable in last night and ran up the Conzult software to find that it says that the AFM meter while running is 5.13V.

Workshop manual says less than 5v when ACC 'On', 1v - 1.5v ish when running. But i swap AFM with my dads and it was the same.

Any help where to look?

Wes

At idle i think mine is around 1.15

Not sure what the problem is.

if you plugged in a 2nd afm and got the same reading then theres a short in your wiring, as its reading the supplied voltage.