Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.

Check your Treg Hitches

General Tech Talk

Moderators: toaddog, TWISTY, V8Patrol, Moderators

Post Reply
Posts: 2877
Joined: Mon May 10, 2004 9:46 pm
Location: Goodna QLD

Check your Treg Hitches

Post by ludacris »

Ever since I got my treg hitch the bolt that is welded to the hitch was looking a bit sus. Not welded properly so I kept an eye on it.

I was always swapping the treg to the ball as I only had one trailer hitch. I got hold of another hitch so I started to fit the treg hitch to its permanant home and as I tightened it the weld let go on the bolt.

I knocked the bolt out and whoever welded it needs his arse reamed.

There was maybe 4mm by 1mm of penetration around the whole bolt which would be about 30mm to 40mm in diameter.

I decided to fix it myself so I die grinded the hole out and the bolt down then migged it up. She aint coming loose ever again. Image is very poor but you should be able to tell that the bolt is no longer flush with the hitch.

Image[/img]


[/img]ImageImage
Cris's 4 X 4 Accessories & Suspension 0404 736 325 Rock Sliders From $499
Posts: 1918
Joined: Fri Aug 26, 2005 4:28 pm
Location: Melbourne

Post by GUtripper »

Good point Cris, lucky you got onto this. Most ppl would never think to look.

Also a reason safety chains are a good idea (with suitable welds onto the drawbar and a suitable attachment point on the vehicle chassis/towbar).
Posts: 4330
Joined: Tue Jun 08, 2004 6:06 pm
Location: Central Victoria

Post by coxy321 »

Try putting your camera into "marco mode" (usually a button with a picture of a flower) for taking close up shots like that. They'll be a helluva lot clearer.

Lucky you got onto the dodgy weld at the right time too!
Posts: 139
Joined: Wed Jun 18, 2008 7:51 pm
Location: NSW

Post by highwaychook »

That's very poor form. Very lucky mate.
Posts: 2877
Joined: Mon May 10, 2004 9:46 pm
Location: Goodna QLD

Post by ludacris »

Thanks guys. We were very lucky and I hope this info saves others from a potential disaster or a bad situation out bush.

Cris
Cris's 4 X 4 Accessories & Suspension 0404 736 325 Rock Sliders From $499
Posts: 4426
Joined: Mon Mar 22, 2004 4:39 pm
Location: Sunshine Coast

Post by bru21 »

welding bolts is bad enough engineering in itself - without doin it poorly!
ADHD Racing would like to thank
Mrs Bru @ Sunshine Coast Developmental Physiotherapy - www.scdphysio.com.au , Ryano @ Fourbys www.generaltire.com.au Blitzkrieg Motorsport
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests