Outer Limits 4x4 Board

Can I fit an exhaust from a 2.8d on a 2.4d??
Is a 2 1/4 inch exhaust from extractors back.
Its off a dual cab and mines a dual cab.
I also have a set of extractors.
This is probably a dumb question but I thought Id ask anyway.

Im just after a yes or no.
Thanks

Come on guys, if this is just a dumb question and the answer is a definite no, then just say no.
If it will fit, just tell me.
Someone must know the answer.

yes yes it should, the side of the head has 4 bolt holes for each port, this allows fitment between the two, although i think i remember that the stock 2l headers didnt fit the 3l???,

I know 100% that 2lt and 2lte is interchangeable with the 3l.

its an early 2L so therefore it wont.
early 2L manifold pattern is: \\\\
late 2L,3L,2L-T,2L-TE manifold pattern is: /\/\
If the extractors that you have now fit, then yes the exhaust will fit if the outlet of the extractors are 2 1/4 or 2inch.

How much is the exhaust?
seriously doesn't cost much for a new system
Mine was $300 from turbo back 2.5inch.

this is true, not alot, but 300 is 300 if you dont have to spend it, only one way to find out

Thanks guys, the exhaust is on here and $50, so a bargain at that, the extractors were freebies, genie 4-2-1.
And Dan, I never thought about checking if the stock headers and the extractors run the same way, I just assumed they were the same.
Ill check them today.
And I think Ill buy that exhaust too.