Page 1 of 1
1.6 adaptor plate?
Posted: Thu Mar 11, 2010 6:11 pm
by chester_390
anyone have instructions how to fit this? do u use sierra or vittara engine mounts etc????????
Posted: Thu Mar 11, 2010 7:05 pm
by nicbeer
what plate / kit did u get or have u got?
Posted: Thu Mar 11, 2010 8:06 pm
by matsmad
I used this kit off ebay. very easy to fit came with everything u need. so much easier than making it up yourself!
http://cgi.ebay.com.au/Suzuki-Sierra-Sa ... 19ba7387ca
Posted: Fri Mar 12, 2010 9:14 am
by chester_390
I got the kit offsuzistore came with mounts the plate and bolts but no isntructions cos the mounts are different but then I dunno if u use the Sierra ones or the vitara ones on the block
Posted: Fri Mar 12, 2010 9:21 am
by nicbeer
Have u thought to ask suzistore?
but yes BenTs kit is good.
Posted: Sat Mar 13, 2010 9:54 am
by chester_390
yea i emailed them but got no response
Posted: Thu Mar 25, 2010 12:13 pm
by zookeenie
use the sierra engine mounts,but you will have to cut a small section out of the clutch cable bracket where it fouls with the r/h engine mount. when you have it all ready to go back in,dont tighten up the new mounting plates for the engine mounts(the black ones that came in kit)untill you do a trial fit,this way they are easily swapped around if required,once happy with position tighten up and bolt to engine bay...hope this helps..