Outer Limits 4x4 Board

my old man has a nh 3L v6and when i had my surf i was going to get a mate to make a diff and lower arm dorp kit to drop the lot 2inchthen put a 3inch ball joint spacer in so i could wind the torsion bar all the way down nearly and still be a bit higher then when i stared the main idea was to get rid of cv angle now the problen is my old surfhad the torsin bar on the top arm but the old mans it is on the bottom im not sure if this will work still but any help would be great and sorry 4 spelling mistakes

I wouldnt be worried about the spelling. I nearly passed out because I couldnt take a breath due to the lack of full stops!!

I am still not sure exactly what you were planning but I think you will still have CV issues. The only way is to drop the lower arms somehow and therefore lower the connection between the hub and the cv to get increased clearance. This can only make the angle greater.

i was plaaning to drop the diff and lower arms but wasnt sure if i could because of the torsion bar being on the lower arm not the uper arm. like my surf was

This should answer your questions:

http://www.outerlimits4x4.com/ftopic1462-0-0-asc-.php

http://www.outerlimits4x4.com/index.php

thanks mate very helpful