Outer Limits 4x4 Board

I need to find out the standard sill height of a zook [sierra] ?

The engineers needs to know the standard height of a zook vs the height of my Gravitron zook. Getting it engineered with 35s on it seem to be impossible, I`ve got a set of 33s he thinks will pass. But I need the ride height at sill level, I may have to lower mine, just for the engineering stage, [ lift it up again later ].

Local engineer ?

lakes edge
'

Athol

i got one here i can measure. do u want it sitting on level ground and measured from the ground to the bottom of the sill.


also i have 205/70R15 tyres on there so its as low as it gets. stock springs too.




ok just went and did it anyways. 41.5cm at the bottom of the sill (approx the middle of the door) to the floor.

thanks buddy.

With my 35s on I`m 13.4 " higher

how much higher are you allowed to be.Sounds high when you put it like that,but it looks the goods

gumtree wrote:i got one here i can measure. do u want it sitting on level ground and measured from the ground to the bottom of the sill.


also i have 205/70R15 tyres on there so its as low as it gets. stock springs too.




ok just went and did it anyways. 41.5cm at the bottom of the sill (approx the middle of the door) to the floor.

If they are stock springs they've probably sagged a bit from the original height...

I'd add another couple of cm to get the "factory" height...

Bent zook , Whats the distance between the bottom of chassis rail and ground?


Ancient thread http://www.outerlimits4x4.com/ftopic33747-0-0-asc-.php

Crh : 560mm 22"