Page 1 of 1
got the wobbles
Posted: Mon Jun 14, 2004 6:50 pm
by flexy trol
gooday fella's I've got a flat tray GQ which has a calbah 5link installed and its just developed a shimy when you hit a bump. I've checked a few things like wheel balance and alignment caster is 3 degrees wheel bearings are good, your input would be much appreciated.
Posted: Mon Jun 14, 2004 6:52 pm
by Daisy
panhard bar
higher it goes.. more wobbles u get due to panhard bar long longer being effective.
a drop bracket for panhard perhaps??
TOM
Posted: Mon Jun 14, 2004 8:11 pm
by hotrod4x4
u dont mention how much lift
mine was fine up to 4-5inch
above that it was crap
but yeah , just go with new panhard bushes and alike to tighten everythin back up
but otherwise , those front ends r known for it
Posted: Tue Jun 15, 2004 12:17 pm
by bru21
drop the panhard. it fixed my gq wizard 5 link 7 inch.
drop it till it lined up with the drag link, than re allign the panhards lateral position. make sure winch / bullbar is on as this affects it too, before aligning the new position.
i tried EVERYTHING first. only this works. don't look for alternatives fix the panhard first.
cheers bru
Posted: Wed Jun 16, 2004 7:41 pm
by flexy trol
thanks guys, after I drop the mount I might put new bushes in the rod any Ideas on which bushes are the best?
Posted: Wed Jun 16, 2004 8:56 pm
by Daisy
flexy trol wrote:thanks guys, after I drop the mount I might put new bushes in the rod any Ideas on which bushes are the best?
Cant get any better than the geniune nissan bushes from what i've heard..
Posted: Thu Jun 17, 2004 1:58 pm
by HeathGQ
or the blue ones from Dobinson.... make sure its the softer ones. The hard ones break.
Posted: Thu Jun 17, 2004 4:52 pm
by bazzle
