Page 1 of 1
lockright locker compatibility
Posted: Sun May 09, 2010 3:16 pm
by maddog_75
hey all,
i've been looking around on their website and throughout google for somewhere showing a chart/list for applications on which locker fits which car.
i did however notice that on the locktup4x4 website that the 40 series 9.5" lockright and the 73-75 series 9.5" lockright have both the same 'model' numbers on the bottom of the page.
can anyone confirm if this is true? is the 40 series and the 75 series diffs the same?
cheers,
george
Posted: Sun May 09, 2010 5:22 pm
by HANCOCK
yes they are and 60's are as well.
Posted: Sun May 09, 2010 6:46 pm
by maddog_75
that only applies to the rear diff of the hzj75, right? the front diff is 8", yes?
bit confused though, on the arb website for air lockers it says that the locker for my rear diff is a rd142, and it says that an rd142 is for the toyota 8.9" diff?
so yeah, what gives? my hzj75 was built in late 97, but sold as a 98, yet also in the arb charts there is no 98 model for air lockers, just up to 97.
fk i'm confused...
Posted: Sun May 09, 2010 7:22 pm
by HANCOCK
Yer sorry the later model 75's has the 8" front diff the earlyer have the 9.5 up too when not shore what and all the rears are the same.
Posted: Sun May 09, 2010 7:37 pm
by maddog_75
cheers for the help otherwise, hope someone else can help me out about the 9.5 and 8.9 inch rear diff issue
Posted: Sun May 09, 2010 8:09 pm
by sava75
If interested, I have a 'LOKKA' part number LR13 brand new in box from 4wd systems which I am not using. $550 and I could post it anywhere in Australia. Bought it for a 1987 BJ73, will fit most cruisers (NON LSD)
Posted: Sun May 09, 2010 8:18 pm
by maddog_75
did a little research, apparently the k085 diff (this number is also stamped onto my little metal plate in the engine bay) represents the fact the car has a 9.5" diff with LSD in the rear.
anyone else to confirm?
in that case, the only 9.5" diff on the arb website is suited to the rd152 locker which is no where to be found in the lc 75 section of lockers.
Posted: Mon May 10, 2010 10:34 am
by anzac
with the 905" rear diff wouldn't that make your truck an early 79 series?
look under pre 2007 70 series and you'll see that the early 78/79 series require an RD152 for toyota 9.5" 32 spline
that may be the answer for you.
here is the link to ARB's application charts page for you download
http://www.arb.com.au/products/arb-air- ... Charts.php
I can supply either air locker or 4wd systems lokka to suit your truck if you are interested.
Posted: Mon May 10, 2010 3:19 pm
by maddog_75
but i thought the 78/79 series had coil fronts and spring rears?
hmm, i think i might just go to a toyota specialist (not toyota) and ask them if they can determine what i'm running.