Outer Limits 4x4 Board

Hi all, I run a GU ute 42TD Manual with an ARB front bar, lowmount winch with the control box sitting in cutout just below grill the question is can i run 3 Lightforce 240 blitz in the centre section of the bar i'm aware that i would have too drill new holes and the lights will stick out past the front of the bar as i measure they should fit but i'm not 100% has anyone done this or know of it to be done? Do they fit? i'm also concerned with restricted air flow will it affected engine temps or cause overheating problems.


If anyone has any pic's of what this looks like i would love too see.

Thanks Blinky

my arb bar and lightforces dont know if they are hte model you mean but might help.



side on



mine have about 1cm of packing under them so they dont have to sit too far forward.

Blinky900 wrote:Hi all, I run a GU ute 42TD Manual with an ARB front bar, lowmount winch with the control box sitting in cutout just below grill the question is can i run 3 Lightforce 240 blitz in the centre section of the bar i'm aware that i would have too drill new holes and the lights will stick out past the front of the bar as i measure they should fit but i'm not 100% has anyone done this or know of it to be done? Do they fit? i'm also concerned with restricted air flow will it affected engine temps or cause overheating problems.


If anyone has any pic's of what this looks like i would love too see.

Thanks Blinky

All im commenting on is yes it will affect he air flow, no need to fit 3 lights.

Just get the pair and fit a hid kit if you want brighter lights...

plus in my opinion 3 lights across the bar looks like shit and more shit to steal and break at the same time...

spend $225 to get the HID retro fit kit and you definitely won't need a third light. It'll work out cheaper and better.

i have 3 lightforce 240xgt in the front off my gu patrol its an arb bullbar