Page 1 of 1
EFI wiring for Rover seires 1 v8 3.5
Posted: Wed May 19, 2010 8:20 pm
by andyGQ
i have just got a new engine for my hilux
Does anyone have a copy of a EFI Wiring diagram.
I was just looking for the basic's to get the engine running.
Ie Igntion feed, fuel pump power Ecu constant power.
just colours and pin outs for ecu.
Posted: Wed May 19, 2010 8:59 pm
by team_little_legs
Rover efi (flapper) wiring details and colours:
Brown wire goes to battery live +,
White/Red goes to crank side of ignition switch (only live while turning engine over),
White goes to Ignition switch live (ONLY live when in run position),
Purple/white is + feed to fuel pump,
In engine bay there will be a single black/white wire usually with the airflow meter loom, this has an inline resistor MAKE SURE THIS IS FITTED, this then goes to the negative side coil for efi ignition trigger to tell the ecu engine is running and to fire the injectors,
Two black wires with ring tags on, these must go to a very good earth.
i think thats what you after its off a forum i found ages ago
cheers
Posted: Sun May 30, 2010 3:33 pm
by Geoffro
Sorry to hijack the thread, but is it the same for the 3.9?
I am putting one in a 2 door.
Thanks
Geoff
wiring
Posted: Sun Jun 06, 2010 8:47 am
by andyGQ
hey guys tried to wire it yestarday but the info that was posted doesnt match the the colour codes in my harness does any 1 have a ecu pin out for this injection system