Page 1 of 1
aftermarket guage for car lpg tank?
Posted: Thu May 20, 2010 7:57 am
by howsie
hey as per title i have a cruiser on gas and the factory gauge is stuffed. Apparently i could replace the switcher with another one but was wondering if there were better aftermarket options out there
Posted: Fri Jun 04, 2010 5:16 pm
by Utemad
You can buy analogue gauges to suit LPG tanks. Pull the valve cover off you LPG tank and see what ohm range it is. 0-60 ohms is most common. You can change this part over to suit your factory fuel gauge too.
Posted: Fri Jun 04, 2010 6:55 pm
by pcman
0-90ohm is the most common lpg sender
i know autometer make a gauge to suit dont know about any one else
Posted: Fri Jun 04, 2010 7:44 pm
by Utemad
Yep 0-90 is what I meant to say.
I was going to buy one from here.
http://www.egauges.com/eg_typeI.asp?Typ ... l&Manf=All
But never did.
I was also going to replace the sender with a different ohm range to suit my factory gauge but the only place I could find that would sell me a sender wanted about $65 for it. Most places wouldn't sell one at all.
Posted: Fri Jun 04, 2010 7:46 pm
by Utemad
Yep 0-90 is what I meant to say.
I was going to buy one from here.
http://www.egauges.com/eg_typeI.asp?Typ ... l&Manf=All
But never did.
I was also going to replace the sender with a different ohm range to suit my factory gauge but the only place I could find that would sell me a sender wanted about $65 for it. Most places wouldn't sell one at all.