Page 1 of 1

exhaust temp at 650 degrees on td gu ute

Posted: Thu May 27, 2010 7:00 pm
by matty
just want some sugestions why its running so hot boost is at 8 and fuel is right down any answers is the pump need rebuilding

Posted: Thu May 27, 2010 7:05 pm
by Dzltec
Celcius or farenheit, where is the probe situated, is the guage accurate?

How much power is it making, what engine, what mods??



andy

Posted: Thu May 27, 2010 7:22 pm
by matty
celcius there mods are 3 inch exchaust 33 tyres not much ekse no real engine mods i took it to a disiel mob to turn the boost up and they said the temp was sitting at 650

Posted: Thu May 27, 2010 7:49 pm
by ETU47
brisbane dyno at woolloogabba they know there shit!!!!

Posted: Thu May 27, 2010 11:19 pm
by ludacris
matty wrote:celcius there mods are 3 inch exchaust 33 tyres not much ekse no real engine mods i took it to a disiel mob to turn the boost up and they said the temp was sitting at 650
Did the shop give there thought of why it is happening. Buy a piro so you know for yourself.

Cris

Posted: Thu May 27, 2010 11:22 pm
by toughnut
My truck used to run between 620 and 650 even after all the mods. 650 was my limit for most things. :twisted:

Posted: Fri May 28, 2010 7:08 am
by Dominator
I have a pyro mounted in the exhaust manifold (pre turbo) and under load, say going up a decent hill on the highway it can climb up to 650. With the sierra on the trailer behind it will get up to 700. That is with N/A pump (wound right out), 13psi and a dyno tune. AFIK 650 is fine, but i would invest in a pyro. good insurance.

Posted: Sat May 29, 2010 9:29 am
by Rhysta
650 is fine for a pre turbo reading a little on the warm side if it is a post turbo reading.