Outer Limits 4x4 Board

Hi i was wondering if anyone had some specs on cutting part of the rear wheel arch out of a gq lwb so 35's wont scrub. i already have cut 1/4's and a 5in coil lift. currently has 2in blocks, but there coming out..

i remember seeing a thread about it a few yrs back but can't find it.

cheers,
Tyler.

p.s. already tryed searching for hours!

mark gaurds, cut with angle grinder, if needed youj can noth and fold a section back to create a lip or kust fit a side fitting type flexi gaurs as available from truck places, touch up the exposed metal with some killrust or similar

cant find the during pics, but heres some finished product ones

http://www.outerlimits4x4.com/ftopic141 ... highlight=

sorry got no picts , but it's not that hard to do . as said before , just mark out the Raduis that you want to cut and go for it .
But , if you cut out more than about 10-15mm , your left with a gap between the outer skin and the wheel arch tub . the more you cut , the bigger the gap . I cat about 30mm out and for the lower part of the rear wheel arch the was about 15mm .
all id did was weld a 20mm wide strip of 1.2m/s back in to cover up the gap and seal the inner gaurd ( this also give you somewhere to fix the flares' to . came up realy well , but I did repaint the rear quarter .

Mine are cut back to the inner guard and the lip roughly tapped in with a persuader. They are 36's tucked in there and they only just rub on the flare on the back edge. That's with extended lower arms too.

my gq has 36's and doesnt scrub at all it only has the lower part of the quarters choped off and its on 5 inche coils