oil supply for turbo on 1hz???
Posted: Mon Jun 07, 2010 5:05 pm
where should i pick up the oil to supply the turbo on a 1hz ?????
Outer Limits 4x4 Board
Aussie Hardcore Wheelers
https://outerlimits4x4.com.au/
oil supply for turbo on 1hz???
Page 1 of 1
Posted: Mon Jun 07, 2010 8:22 pm
'T' in behind the oil pressure sender mate on the opposite side of the block
Posted: Mon Jun 07, 2010 8:37 pm
As Z()LTAN said simply T off the oil pressure sender and run the braided oil line up and over the back of the engine. Use a piece of rope etc to dummy fit and measure the size needed then go to pirtek or enzed and get one made up.
Oil pressure sender has a 1/8 NPT thread.
Have fun.
Oil pressure sender has a 1/8 NPT thread.
Have fun.
Posted: Mon Jun 07, 2010 8:53 pm
thanks for that!!and what about the water line??and zoltan i did get a 2876r after all
Posted: Mon Jun 07, 2010 9:27 pm
hehe u wont be displeased believe me!
Water lines you T into the heater hoses on each side of the heater core.
Water lines you T into the heater hoses on each side of the heater core.