Outer Limits 4x4 Board

hello guys i am wondering what people have done to connect there 4inch snorkel one with rubbber bends.
i have a 4.2 efi gq.
picture would be great
cheers





EDIT:
title altered for search function.


Kingy

I've retained the original airbox which is 3" in and 3" out so I used a rubber 4"-3" reducer which I bought off eBay and then connected to original plastic 3" ducting. I also used 3" flexy tubing from supercheap in between, only because my snorkel is midway up front guard as I used to have an airflow snorkel so needed to use existing hole.

I did pretty much the same as above , got a 4 in to 3 inch reducer and some convuluted tubing in 3 inch to the original air box . was on a gq 4.2 carby .

i got a proper airbox made with a 4" inlet, and proper pipework under the bonnet.

expensive option, but horses for courses...

Hi guys

what is the little tube that connects to the duct just before it hits the engine bay wall. does it need to be fitted. Mine has broken off, after you guys have been fitting snorkels with different pipe, are you reconnecting it?