Page 1 of 1

1kz-TE Glow plug indicator KZJ96

Posted: Sat Jul 03, 2010 2:16 pm
by nicinnz
Hi got an issue with my glow plug indicator light it only comes on for about 1.5 seconds.
I have new genuine Toyota glow plugs, they do continue to glow for about 15 seconds even after the light goes out so I just wait ten seconds before starting. A friends Prado glow light stays on allot longer than mine.
Anyone got a clue to what could be the problem? Maybe a temp sensor? If so where is it located?

Re: 1kz-TE Glow plug indicator KZJ96

Posted: Sat Jul 03, 2010 9:42 pm
by ferrit
My 93 Surf 1KZ motor does the same thing- so i just wait for my boost gauge to go thru its startup cycle before cranking and it normally works fine! :armsup:

Re: 1kz-TE Glow plug indicator KZJ96

Posted: Sun Jul 04, 2010 3:04 am
by popeyehj60
does it start fine if u start it as soon as the light goes out

Re: 1kz-TE Glow plug indicator KZJ96

Posted: Sun Jul 04, 2010 2:27 pm
by nicinnz
No it doesn't start straight after the light goes off you have to keep cranking it, I usually wait for 10 seconds of so (I wait until the electric aerial has fully extended, make a good timer) It been -2 to -6 degrees here in the mornings

Re: 1kz-TE Glow plug indicator KZJ96

Posted: Sun Jul 04, 2010 7:01 pm
by oldmate
5 seconds is long enough. Direct injection motors kick over easy anyway.

Re: 1kz-TE Glow plug indicator KZJ96

Posted: Thu Jul 08, 2010 8:13 pm
by ferrit
1KZ-TE's are an Indirect injection motor... bitch of a thing to start if your plugs fail too...