Help PLS -IRS unit bearing dimensions
Posted: Wed Jul 14, 2010 11:51 am
Hey guys,
I am just wondering if anyone with an IRS paj could climb under and check a few measurements for me?
Basicly i am just wondering how different the bolting flange dimensions are for the rear and the front unit bearings. You know the 4 bolts that hold the bit on that the outboard cv goes through the 'splindle'. Mitsu run unit bearings as opposed to the likes of toy/nissan ifs that run a stub axle.
Any help much appreciated.
I am just wondering if anyone with an IRS paj could climb under and check a few measurements for me?
Basicly i am just wondering how different the bolting flange dimensions are for the rear and the front unit bearings. You know the 4 bolts that hold the bit on that the outboard cv goes through the 'splindle'. Mitsu run unit bearings as opposed to the likes of toy/nissan ifs that run a stub axle.
Any help much appreciated.