Page 1 of 1

Baleno engine issue

Posted: Wed Aug 04, 2010 1:51 pm
by sierrajim
My 1.6 twin coil pack Blaeno motor (with Jimny auto) has a miss/hesitation under load on accelleration.

The check engine light comes on when this happens. The diagnostic tool we have here won't talk to it.

The TPS is new, fuel pressure is OK, under light load/accelleration drives fine. when it gets past that particular load spot it also drives fine.

Any ideas?

Re: Baleno engine issue

Posted: Wed Aug 04, 2010 5:29 pm
by V.W.Dave
Hey jim
I am about to put this engine into my sierra, In doing so I did a bucket load of reading on the pros and cons of this engine. This problem was raised quite a few times with the balino guys that pushed them for power. I found a bunch of info on redlinegti.com and twincam.org. From what I read the common problem are air temp sensors, faulty T.B. and faulty coil packs.
But that is what I have read on the net so who knows.

Re: Baleno engine issue

Posted: Wed Aug 04, 2010 8:16 pm
by mr green
check your spark plug tubes for signs of the spark jumping out the side to the head. will look like a pin hole with white soot around it. otherwise swing round one arvo and i'll have a look for you! :D

Re: Baleno engine issue

Posted: Thu Aug 05, 2010 9:58 am
by sierrajim
Cheers guys.

Have tested, checked and cleaned plugs, sensors, termainals etc.

Now have a new coil pack, cam sensor and map sensor on the way. Will swap bits out one by one to isolate the problem.

Re: Baleno engine issue

Posted: Tue Dec 07, 2010 9:42 pm
by bakerboy
any joy? mines doing this now, will bog down and try to stall under WOT but feed it lightly and its fine

Re: Baleno engine issue

Posted: Sat Dec 18, 2010 7:40 am
by sierrajim
Yes, there's a little valve that threads into the manifold that the MAP sensor takes its vaccum from. When bypassed it ran fine. So as originally thought was a MAP problem, just not the sensor itself.