Outer Limits 4x4 Board

Just renewing clutch and want to replace the spigot bearing. Any one changed the spigot bearing and how?

Ahh its not a bearing its a brass bush.

Ok got the spigot bush out with wet paper, it was so easy. I got a exedy HD clutch kit and instead of a bush i got a bering that was half the size!
I had to order a genuine bush from toyota, no one has them.

The manual shows a bearing but the proper part is a bush. This bush was worn causing lots of vibrations ans noise. So check your spigot bush when replacing your clutch.

With a bearing the clutch-gear works more softly and last longer i have changed mine 2 years ago and no problem since then.

Did you have the bush and replace it with the bearing?

Both my ferozas had a bearing in that place.
As far as I know Daihatsu has two different codes for that bearing.
I found a different bearing in each car.
Never heard about a bush till now.

chugga wrote:Did you have the bush and replace it with the bearing?

Yes and now it doesn't make that terrible noise since then because the bush was almost cut in half

Why was yours cut in half? I wish i did put a bearing instead of a new bush

The bush its since 1992 and it was destroyed after 18 year, don't worry also yours will last for a long time