Outer Limits 4x4 Board

Hi everyone,
This might seem like an insignificant problem, but I need to replace fix the lights on my heater controls. Problem is, I have looked and fiddled, but have not ben able to find any way to get the panel out. The answer is probably staring me in the face, so please excuse my blindness.

jim80h wrote:Hi everyone,
This might seem like an insignificant problem, but I need to replace fix the lights on my heater controls. Problem is, I have looked and fiddled, but have not ben able to find any way to get the panel out. The answer is probably staring me in the face, so please excuse my blindness.

I have the backlight for the heater controls out also...when I can be assed to fix it, I'll tel you how...until then, better get your muscle memory up to scratch

From memory, the globes are the little "grain of wheat" bulbs.

Again, from memory, the panel should unclip, I thnk you have to remove the heater knobs first though. I'm pretty sure there's a section on it in the workshop manual.

i would like to know how to fix it aswell as my lights havnt worked for years.

BTW, sometimes it's just that the globes aren't seated properly/connection becomes dodgy over time. So sometimes a bit of a whack on the panel with your knuckles will get 'em going...

AJFeroza wrote:BTW, sometimes it's just that the globes aren't seated properly/connection becomes dodgy over time. So sometimes a bit of a whack on the panel with your knuckles will get 'em going...

If it don't work, hit it. If that don't work, kick it....