Page 1 of 1
Sierra 13b conversion
Posted: Wed Sep 15, 2010 7:11 pm
by ZookiDave
Does anyone know of anyone that has put a 13b rotory into a Sierra and wot gearbox was used for the conversion.
Re: Sierra 13b conversion
Posted: Wed Sep 15, 2010 7:59 pm
by V.W.Dave
I have only seen 3 one of them was on youtube the others were in buggies. There is always much debate on this subject I personally think they are a great engine and they have there place but I would never put one in a four wheel drive that wasn't a buggy. Most I have read up on run the RX 5 speed behind them then through a geared sierra transfer.
If you get on Auszookers.com there is a guy building one and he has a build up thread on it.
Re: Sierra 13b conversion
Posted: Wed Sep 15, 2010 8:18 pm
by ZookiDave
cheers mate, i have the same question up on there and got posted the link 4 the build.
Re: Sierra 13b conversion
Posted: Tue May 24, 2011 11:00 pm
by MazdaSpater
Doing a 12A, just rebuilding motor, left room for the 20mm stretch later on.
Buildup thread to be done too. Cold here, probably a good time to start that now the zook is too tall for the shed.
Chris.