Outer Limits 4x4 Board

Hello,

Next month i will be buiyng some new rubber and was looking at 35's. Now i have 33's on it and when the wheels are turned there is some space but not much. So will 35s fit and there will be millimeters when wheels are turned or i will need to buy spacers?? Because if i can i would want to run 35s

Cheers

4x4boi wrote:Hello,

Next month i will be buiyng some new rubber and was looking at 35's. Now i have 33's on it and when the wheels are turned there is some space but not much. So will 35s fit and there will be millimeters when wheels are turned or i will need to buy spacers?? Because if i can i would want to run 35s

Cheers

With you three inch body lift I would say you would OK .. you may need to get friendly with a BFH to make some minor clearances ..

(BFH Big F-ing Hammer)

BFH- haha i like that Will i took a pic of it to show you guys, what you think that 35s will fit or its a no go




Cheers

I've got 35's on my '94 and really big 35x13.5's (as tall as most 36's) on my '99, both only have only a 2" body lift and i rolled the fenders with a pipe instead of the hammer method for the most part. They barely scrub, when i had a 2" suspension lift on my '99 they didn't rub at all but i took that out for a better CG.

hi i have 35" x12.5" and thay do not hit but i have 2" body lift & 2" suspension but not happy with it off road so them go to do a solid axle swap and a 4" lift but they well fit just you well not have much down travel

Have you cut the front bump stops and done the ball joint flip or just raised the torsion bars Baz305?