Outer Limits 4x4 Board

Hello,

This weekend i want to wire my top lights in on the paj. But cant figure out where to pull the cable down, because i dont want to drill the top of the car.
Anyone have any ideas or if someones has done this can you guys post a pic or something?

cheers in advance

If you don't wanna make holes, then you could clip the wire down the A pillar and sneak into the bonnet. Done that before, but doesn't really look too permanant.

hey mate, Im not sure if you can see from this photo but I made up my own "rack" to keep my lights on and zip-tied the electrical wires down the rack, just past my drip rails and through the cab there. I was a little lucky, my ute has a piece of black plastic that I took off and drilled a hole in the cab to poke the wires through there, with a rubber grommet to protect the wire. hope this helps



Chad

yea thats not a bad idea actually, I can do that even with my except my lights are on the roof cage but, i reckon your way will work will give it a go this weekend and post up pics of how it turend out

Cheers Chad

Hey guys,

Just one more question For the wiring i have some pretty buff cables for it, but what i would like to know is that which is better? From each light ( I have 4) the wires come down seperatly OR from everylight the wires go onto one Main wire that goes down??

Cheers

dont know if this is right but I used thicker wire and joined 2 lights to the one power wire and ground wire. So I halved the amount of cable running down. you should have 2 power cables and 2 groung wires coming down then. I have had mine wired like this with no prolems at all. make sure the wire you use can handle the amps running through it or youll have problems

Hey,

Will i got em wired up this weekend, turned out pretty good Heres some pics.






Cheers

Cable tie the wires down the gap between the snorkel and the cab!! Haha I'm serious though...