Outer Limits 4x4 Board

Hi . I have nissan patrol mq 1982- 1984 with c200 axles 29 spline front and rear. I am looking for stock or stronger axle shafts. Do you know where a can buy?

Thanks.

Stock axle shafts are good up to 35"(simex, silverstone etc.) and even for bigger less agresive tires.
In the rear just fit H233B axle with the same gearing - it is much stronger than C200.
Also rear C200 had LSD, which you can fit in front axle.

Thanks ,i know that. I have those axles on susuki samurai with 35' tyres. i have all ready arb front and rear and it's difficult to change the complete axle . I want half safts front and rear . Please if you know where i can buy tell me.

thanks

anyone who knows where i can buy half shafts?

I am in Greece and i don;t know any site can you help me?

Half Shafts?
CV?

WICKED wrote:Half Shafts?
CV?

Axle Shafts

MANOSF wrote:

WICKED wrote:Half Shafts?
CV?

Axle Shafts

No one makes an upgraded Axle for the C200. You can use GQ CV's but that's it.

The problem with rear C200 diffs is that it's snapping axles in diff centre, where they are thin. H233B are few mm bigger and a lot more durable.

I am looking for stock axle shafts. can you tell me where i can find ? If you know give me e mail address.

wrecker's ?, ebay ?, Nissan ?

The best option to aquire a half shaft is to just contact your local nissan dealer and order them.
Nissan partnumber 39100C7400 for the RH side and 39101C7400 for the LH side.

I've never snapped one in ten years.
Don't run full locker in the front that's best.