Hi All,
Rebuilding my front axle and I am at the point of putting the new seal which sits on the back of the stub axle. How do you press the seal on all the way to stub plate with out fouling up the seal lips?
Just take a rubber mallet / chunk of wood to her and she'll be right (removing the spring first)?
Cheers
Notice: We request that you don't just set up a new account at this time if you are a previous user.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
If you used to be one of our moderators, please feel free to reach out to Chris via the facebook Outerlimits4x4 group and he will get you set back up with access should he need you.
Recovery:If you cannot access your old email address and don't remember your password, please click here to log a change of email address so you can do a password reset.
GQ Stub axle seal installing
GQ Stub axle seal installing
"I can picture in my mind a world without war, a world without hate. And I can picture us attacking that world, because they'd never expect it." - Jack Handy
Re: GQ Stub axle seal installing
thats how i did mine, and lube up the back of it (stub axle side) so it slides on a little easier, probably not the best way to do it but it works just gotta be careful while your doing it not to belt it too hard.
Re: GQ Stub axle seal installing
also be careful not to get too frustrated when it doesn't go in and then you try and smash it in 
Who is online
Users browsing this forum: No registered users and 106 guests