Outer Limits 4x4 Board

hey i just brought some ifs rear leafs and was wondering what everyone else has done for bushes if they used the ifs ones or something else

cheers

i used a shackle bush from some toyota? cant remember the part no or model but they had a few packets of them, it was saturday at 4.30 and it was all that super cheap had i think it was a 35mm od and i though it would be to small but if fitted in nice and tight because i left the steel sleave in the leaf i have been told that a poly ifs bush fit nice if you leave the steel sleave out of the center if you look in the bible you should find it there

the bush you need is kelpro 27014.
available from repco for about $9 per half.
sold as half bushes so you need 4 halves to make 2 complete bushes.
remove the stock front anchor pin bushes and replace with these.
think they are from early 1980 model rodeo and jackeroo.

specs wrote:the bush you need is kelpro 27014.
available from repco for about $9 per half.
sold as half bushes so you need 4 halves to make 2 complete bushes.
remove the stock front anchor pin bushes and replace with these.
think they are from early 1980 model rodeo and jackeroo.

Or just run the IFS bush with the IFS bolt.

thanks guys have it sorted just buyin some ifs poly bushes they will work

Just use replacement bushes for IFS and leave out the sleeve to run the 18mm fixed pin.

Matt