Outer Limits 4x4 Board

Hi all,

I think I've scored a BJ40 for a carton of beer. The driveline is good, but a fair bit of rust in the body. Main concern is the back floor at the rear. I'm wondering if anyone knows if and where I can get pressed steel sheeting in the same profile as original so i can just weld it in.

Cheers
Bearded 1

There's a few places in the USA who do replacement steel panels, not sure how it'd cost to get them sent over though.

Try this

http://coolfj40.stores.yahoo.net/bedrearfj19t.html

MrGrim wrote:Try this

http://coolfj40.stores.yahoo.net/bedrearfj19t.html

Thanks mate. That is is one cool site (pardon the pun).

B1

yeah not bad place they supply to most restorers
not cheap but as close to factory as you can get