Outer Limits 4x4 Board

Hey all, Tomorrow i will attempt to repair the Altimeter / Clinometer Instrument Cluster in my 89 surf.. im leaning towards this being a common problem because 3 other surfs i know of, all have the same problem.

Im Sure they work with water, right? It cant be that hard

If anyone has any advice or anything it would be muchly appreciated.. and a big thank you in advance!

Thankssssssss

-loky

If your taking the time to take look at those gauges while wheeling, it's not going to be much of an angle to worry about anyway

SGESCO might be able to help if your in Brisvegas.

Its more for the cool factor, haha.

I guess you could call it OCD, in a way..

Unfortunately not in brissy, living in sydney atm... i'll have a crack at it tomoro, i'll keep ya posted.

Thanks DJ

I find my pucker gauge works heaps better at telling me how bad a side slope is. It's also transferable from vehicle to vehicle. When you're touching cloth it's probably time to reverse out. Only down side is people look at you funny when you try and show them your gauge.

Mr DJ knows what I'm talking about.

, I know you changed your front seats, but was it cause of the smell or the tears in the seat ....

Mr DJ wrote:If your taking the time to take look at those gauges while wheeling, it's not going to be much of an angle to worry about anyway

SGESCO might be able to help if your in Brisvegas.

well i took time to look at those guages in dougs car lol seen it first hand last yr go past the highest degree mark side angle and my ass was clentching the front seat and atrol was pushing the glass in the back to hold him self off the window lol
so in my surf the guages are coming out and im fitting oil water and pyro guages in there. a bit of custom work in stead of having guages on the pillar.

thats what I was planning with mine jnrlux. fit a few 52mm gauges in there if I can. should look pretty and actually be useful

plus hides the guages from those 5 finger little pricks and also the fuzz (boys in blue).

Well, It's fixed! It actually works with weights, and what was causing the problem was the "lock" knob.

What had happened was, the previous owner must have pressed the knob in, fairly hard... to the point where its pushed the 2 plastic casing pieces together, causing it to constantly be locked. (That knob should only be turned, not pushed).

So, re-aligning the 2 pieces of plastic free'd it up.

if anyone wants to see a picture let me know, ill upload it to show you which pieces i was talking about.

thanks guys!!

regards

Lach

the old owner of mine must have done the same as its locked all the time and cannot free it.

tho as i said ill be housing my gauges in there