Outer Limits 4x4 Board

Hi Guys, I made a video showing the complete tear down and re-assembly of a rear full floater hub on my cruiser, covers all cruisers with full floating rear axles. Probably very similar for most other models as well.

have a look if interested:

[YOUTUBE]5lmQE3_oiNQ[/YOUTUBE]


YouTube - Land Cruiser rear hub/axle service, bearings, axle, seals, gasket etc

Regards,

Louis

Thanks Louis! just in time as I need to tear one down ..thanks again for the great Vids.

Nice video mate, i liked the tips through it, like aligning the nut with the groove, its gonna make it a lot easier next time i need to find that bloody hole where the little lock screws go lol. I wonder if 80series have these grooves, i have never noticed them.

Dont like how you loosened the cone washers

Ya, you do what you can at the time, I also use a brass drift when I have one. The drift is better admittedly.

Thanks for watching!

Louis

Don't like how you spell tyre.

Really good vid. Except the gloves bit. If you're going to pack bearings by hand then it has to be bare handed I reckon. Otherwise you've taken all the fun out of it.

LOL, I stopped doing bare hands years ago - when the wife said "you aren't touching me with those hands" Now she has no excuse - but still says it....hmmmmm.

Awesome vid, and I agree, just in time. Cheers!