Outer Limits 4x4 Board

As it says and yes I have read the bible what have people fitted and how hard or easy I have a 94 coil cab Im only 5ft 7 and 68kgs so on the small side not looking for anything with high sides just something comfy for touring.

Duncan

a friend just fitted vx commodore seats to her gq. I belive it was almost a straight bolt in

Thanks will look into it

vy ss seats.

use the existing gq rails, remove them from the gq seats. Bolt a piece of 25mm square tube on the outside rail between the rail and vertical piece that goes to the seat (spacer), bolt straight onto vy seats - took me about 2hrs to do all

B

Thanks very much

VQ statesman seats

vs seats took a day to put in heaps better then the origanals if you go this way put the passenger on the drivers side so the adjusting knobs dont hit the piller

I fitted WRX seats to my GQ ute, took me ages. Sounds like commodore ones are a whole lot easier...

I fitted autotechnica race seats into my gq, they were fairly straight forward, spacer on the outside rail with two bits of 50x8 flatbar to go between the rails as the race seat mounting pattern was a bit narrower. Heaps more comfy then standard, and the wings help keep you in the seat.

Sweet_GQ wrote:vy ss seats.

use the existing gq rails, remove them from the gq seats. Bolt a piece of 25mm square tube on the outside rail between the rail and vertical piece that goes to the seat (spacer), bolt straight onto vy seats - took me about 2hrs to do all

B

I did it the same way as above.. the seats I used ( for front & rear) were jap improt sports seats, real cummfeee
pump up lumber suports & all different styles, I got them from ASIAN AUTO IMPORTS at Kingstone, 2 shops down from the corner of Kingstone Rd & Moss St they were $150 for the pair.

cheers Piggy

I have a sett of GQ seats for sale they are in as new condition including the 3rd row, the drivers seat has only been used for 6 monts.If you are still interested post me an e-mail. I'm open to reasonable offers.

Cheers Gilge

i have fitted redaro's with pump up lumber support to mine and will never look back.
they are a great seat but are on the pricey side..

I fitted up some VR senator seats, once again just spaced up one side and used some 4mm plate to make the rails slightly wider.....


Shot at 2011-03-29